Couplings - Both Male & Female 1" Aluminum Camlocks
Inside Diameter - 1 " inches
Lay Flat Width- About 1.75 " inches
Color - White
Length - Available in 50, 100, BULK 500 or 1000'
Pressure & Uses
Service Pressure - 125-150 psi
Test Pressure - 250 psi
Burst Pressure - 375 psi
Medium Industrial Projects
General Water Transfer
About THIS HOSE
The 1" single jacket hose can be used with any 1 inch camlock setups. These usually include pumps, outlets, and valves equipped with 1" camlock male or female fittings. These hoses are well suited for for irrigation, industrial wash down, and general water pumping applications where medium water pressures are used. Typical hydrant and street pressure do not exceed 100 psi. Woven hose materials are the best way to go because it's strong and long lasting. It has a far higher PSI rating than plastic PVC hose. The inside rubber lined ensures this hose is resistant to holes, tears, and abrasion. Hose is immune to mildew and does not require drying
If you're moving these hoses around day to day, 50 foot lengths are the best way to go. They are lightweight enough to carry around and roll up. For applications where you set the hoses for extended periods of time, the 100 foot lengths are more economical.
How do I connect this hose?
Push the ears forward on the female side fitting.
Make sure the inside of the fitting is clear of dirt and debris.
Insert the male fitting into the female fitting
Pull the ears back and apply pressure to lock down the ears.
When the ears can't go down any further, you're locked.
To release the fittings, pull the ears forward and pull the fitting out.